Pumpkin or Gourd 3D Silicone Mold for Resin Crafting, Fall Table Decor, Halloween, Shiny, Shiney, Silicon Mould, Shiny Mold, Glossy

This listing is for a shiny silicone mold to make a 3D pumpkin and/or gourd. The pumpkin and/or gourd would make great table or mantle decor either by themselves or as a grouping. These pieces are the perfect size!! Not too big to be overwhelming but big enough to have a lot of creative space. There will definitely be room to fit anything you want inside of the piece. The pumpkin is approximately 3.75" in diameter and approximately 2" tall. The gourd is approximately 3" in diameter at its widest point at the base and 3" tall. Please note the stem on the pumpkin will have two 1/4" matte spots on the side of the stem.

These both are DEEP molds. Please check your resin's maximum thickness to avoid an exothermic reaction.

This listing is for the silicone mold ONLY. The pumpkin and gourd shown in the picture are only to give you an idea of the finished piece.

Please message us with any questions you may have regarding this mold.

All molds are handmade and inspected before shipping. All trays are made from stacked acrylic which may cause a line to appear in the mold. (Very minimal)

Our Smoothon Mold Star silicone molds cure to soft, strong rubbers which are tear resistant and exhibit very low long term shrinkage. Our molds will last a long time in your mold library and are good for resin, concrete, wax, gypsum and other materials. The molds are heat resistant up to 450 degrees Fareheit or 232 degrees Centigrade. They are suitable for casting low temperature melt metal alloys.

SILICONE MOLD CARE INSTRUCTIONS

• DON’T TOUCH the inside shiny part of the mold. This will cause permanent scuffs that will show in your final cast.
• Use scotch tape to gently clean the mold. Tap the spot lightly where there are loose particles.
• USE EXTREME CAUTION when using a torch/heat gun to pop bubbles in the resin. It may rip the mold upon demolding your fully cured resin. Instead try a mist of
alcohol over the resin.
• Make sure the resin is fully. Uncured resin may rip the mold.
• Please follow all safety precautions when using resin. It is very toxic.
• Plastic Wrap/Bag Marks on trays will go away within 48-72 hours.
• All torso molds come pre-split to allow for easy demolding of your resin piece. Use the rubber bands to aid you to seal the split upon pouring.
• If you have further questions or concerns about your mold, please shoot me a message on Etsy and I’ll get you taken care of.

PLEASE INSPECT MOLD PRIOR TO FIRST USE. I DO NOT ACCEPT RETURNS OF USED MOLDS.

Customer Reviews

Based on 1 review
100%
(1)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
S
Sharon Russell
Love

Love love these molds