This listing is for a shiny silicone mold to create a Spider Web shaped rolling tray. The size of this tray is approximately 9 x 9 and it's approximately 5/8" deep. The base is 1/4" thick and the walls are 3/8" thick.
Note that all tray molds are made from stacking acrylic sheets which may cause a line in the mold where it is stacked (Very minimal).
The image on this tray is engraved which means it will come out matte. The image will also be recessed into your resin piece upon de-molding.
Please message us with any questions you may have regarding this mold.
**Please note this listing is for the silicone mold ONLY. The dish shown in the picture is only to give you an idea of the finished piece.
Silicone Mold Care Instructions
-Wash Gently when needed with warm distilled water and soap only.
-Don’t touch the inside shiny part of the mold unless under running water. This will cause scuffs.
-Use extreme caution when using a torch/heat gun to pop bubbles in the mold, it may rip the mold upon demolding. Instead try a mist of alcohol over the resin.
-Make sure the resin is fully cured, uncured resin may rip the mold. -Please follow all safety precautions when using resin, it is very toxic.
-All torso molds come pre-split to allow for easy demolding of your resin. Use the rubber bands to aid you to seal the split upon pouring.
-Saran Wrap Marks on Trays will go away within 48 - 72 hours.
PLEASE INSPECT MOLD PRIOR TO FIRST USE, I DO NOT ACCEPT RETURNS OF USED MOLDS.