Clock Insert Mold | 2 Sizes | Clock Mold

Final Cast Dimensions:
 
SMALL: 2.5" in diameter
LARGE: 4 3/8" in diameter

This listing is for a Clock Insert Silicone Mold. This mold is intended to void out a space in your resin so that you would be able to insert a clock that you would purchase into the voided-out area of your resin piece.  The beauty of this is that this will work in any mold that is one inch or deeper: such as an arch, square, or hexagon.  It would look great in our arched rectangle mold.

Small Clock: https://a.co/d/2IVbeG3

Large Clock: https://a.co/d/3o3aEHl

Please message us with any questions you may have regarding this mold. 

All molds are handmade and inspected before shipping.

Our silicone molds cure to a strong platinum rubber which is tear resistant and exhibits very low long-term shrinkage. Our molds will last a long time in your mold library and are good for resin, concrete, wax, gypsum and other materials. The molds are heat resistant up to 450 degrees Fahrenheit or 232 degrees Centigrade. They are suitable for casting low temperature melt metal alloys.

SILICONE MOLD CARE INSTRUCTIONS

• DON’T TOUCH the inside shiny part of the mold. This will cause permanent scuffs that will show in your final cast.
• Use scotch tape to gently clean the mold. Tap the spot lightly where there are loose particles.
• USE EXTREME CAUTION when using a torch/heat gun to pop bubbles in the resin. It may rip the mold upon demolding your fully cured resin. Instead try a mist of alcohol over the resin.
• Make sure the resin is fully cured. Uncured resin may rip the mold.
• Please follow all safety precautions when using resin. It is very toxic.
• If you have further questions or concerns about your mold, please send me a message and I’ll get you taken care of.

PLEASE INSPECT MOLD PRIOR TO FIRST USE. I DO NOT ACCEPT RETURNS OF USED MOLDS.