0

Your Cart is Empty

Silicone Mold Care Instructions

Silicone Mold Care Instructions

  • Don’t touch the inside shiny part of the mold. This will cause permanent scuffs that will show in your final cast.
  • Use scotch tape to gently clean the mold. Tap the spot lightly where there are loose particles.
  • Use extreme caution when using a torch/heat gun to pop bubbles in the resin, it may rip the mold upon demolding your fully cured resin. Instead try a mist of alcohol over the resin.
  • Make sure the resin is fully cured, uncured resin may rip the mold.
  • Please follow all safety precautions when using resin, it is very toxic.
  • All torso molds come pre-split to allow for easy demolding of your resin. Use the rubber bands to aid you to seal the split upon pouring.
  • Saran Wrap/Bag Marks on Trays will go away within 48 - 72 hours.
If you have further questions or concerns about your mold, please shoot me an email at Zapp3DDesign@gmail.com and I’ll get you taken care of. 

PLEASE INSPECT MOLD PRIOR TO FIRST USE, 
I DO NOT ACCEPT RETURNS OF USED MOLDS.