Flower Wine Stopper Top Mold | 3 Styles | Wine Stopper Top Mold

FINAL CAST DIMENSIONS

DEPTH: 1"
DIAMETER Approximately 2.5"
BOTTOM OPENING Approximately .75"
SURFACE FINISH: Glossy/Shiny

This listing is for a Flower Wine Topper Mold. This mold comes in 3 unique flower shapes.

Please Note: This mold comes with 2 splits. One on each side.  The purpose of the splits is to aid in the demolding of your piece.  Without the splits you would not be able to demold your resin piece.  Use the rubber bands provided to seal the slits before your pour your resin.

This listing is for the silicone mold ONLY. 

Please message us with any questions you may have regarding this mold.

All molds are handmade and inspected before shipping. 

Our silicone molds cure to a strong platinum rubber which is tear resistant and exhibits very low long-term shrinkage. Our molds will last a long time in your mold library and are good for resin, concrete, wax, gypsum and other materials. The molds are heat resistant up to 450 degrees Fahrenheit or 232 degrees Centigrade. They are suitable for casting low temperature melt metal alloys.

SILICONE MOLD CARE INSTRUCTIONS

• DON’T TOUCH the inside shiny part of the mold. This will cause permanent scuffs that will show in your final cast.
• Use scotch tape to gently clean the mold. Tap the spot lightly where there are loose particles.
• USE EXTREME CAUTION when using a torch/heat gun to pop bubbles in the resin. It may rip the mold upon demolding your fully cured resin. Instead try a mist of alcohol over the resin.
• Make sure the resin is fully cured. Uncured resin may rip the mold.
• Please follow all safety precautions when using resin. It is very toxic.
• If you have further questions or concerns about your mold, please send me a message and I’ll get you taken care of.

PLEASE INSPECT MOLD PRIOR TO FIRST USE. I DO NOT ACCEPT RETURNS OF USED MOLDS.