0

Your Cart is Empty

Frog Silicone Mold | 4 Sizes |

FINAL CAST DIMENSIONS:
Mini: 1" long, .75" wide, 1" tall - Matte Finish
Small: 1.25" long, 1" wide, 1 1/4" tall - Semi Gloss Finish
Medium: 1.75" long, 1" wide, 1 1/3" tall - Glossy Finish (ORIGINAL SIZE)
Large: 2" long, 1 3/4" wide, 1 3/4" tall - Glossy Finish (Different Style)

This listing is for a Frog Mold. We offer this mold in the 4 sizes shown above. This frog would be so cute stand alone or would also make a great addition to your tray or dish. The NEW large size frog mold is a little different style from the other 3 and has more room for flowers or inclusions.

Please note the different finishes shown above for each mold.


This listing is for the silicone mold ONLY.

Photos and Resin Work done by @mlcresindesigns

Please message us with any questions you may have regarding this mold.

All molds are handmade and inspected before shipping.

Our silicone molds cure to a strong platinum rubber which is tear resistant and exhibits very low long-term shrinkage. Our molds will last a long time in your mold library and are good for resin, concrete, wax, gypsum and other materials. The molds are heat resistant up to 450 degrees Fahrenheit or 232 degrees Centigrade. They are suitable for casting low temperature melt metal alloys.


SILICONE MOLD CARE INSTRUCTIONS

• DON’T TOUCH the inside shiny part of the mold. This will cause permanent scuffs that will show in your final cast.
• Use scotch tape to gently clean the mold. Tap the spot lightly where there are loose particles.
• USE EXTREME CAUTION when using a torch/heat gun to pop bubbles in the resin. It may rip the mold upon demolding your fully cured resin. Instead try a mist of alcohol over the resin.
• Make sure the resin is fully cured. Uncured resin may rip the mold.
• Please follow all safety precautions when using resin. It is very toxic.
• If you have further questions or concerns about your mold, please send me a message and I’ll get you taken care of.

PLEASE INSPECT MOLD PRIOR TO FIRST USE. I DO NOT ACCEPT RETURNS OF USED MOLDS.